FX NETMA CANOPY SYSTEM

What is the Netma Canopy System?

The Netma Canopy system is a transparent and state-of-the-art solution that provides protection against rain and sun, ensuring bright access through the transparency of the glass.

It consists of a system of stainless steel connectors that hold the glass to the wall through tensors, giving an elegant and light appearance to the structure.

VISUAL QUALITY

Clear views from the comfort of light-filled spaces, and a wide range of hues create visual interest when building with light, such as a blue, green, or gray exterior.

SAFETY

It has the quality of our Safety Glass, Fuertex tempered, and Vilax Laminated GLASS.

COMFORT

Glass contributes to a building’s energy performance by affecting both natural light transmission and solar control

Applications:

This system can be installed in applications such as: homes, offices, commercial premises, restaurants, buildings, hospitals, banks, stores, supermarkets, etc.

Accessories Netma Canopy System:

The Netma Canopy System accessories are available in satin and black finish, made of AISI 304 steel with corrosion resistance.

Typical Netma Canopy System Design:

There is a typical design for the Netma Canopy system, as shown below:

Charaterictics:

Possibility of using colorless, colored or sandblasted glass.

Length restriction of 1800 mm of glass.

Stainless steel accessories.

Restrictions:

For the proper functioning of the System, the following must be verified:

The wind speed that will be exposed. The FX Netma Canopy system is not a structural system, however, a stability verification is recommended. This system, due to its characteristics and support points, can withstand wind pressures higher than 40 kg/m² as maximum, so if the project exceeds these magnitudes, other variables must be analyzed in order not to compromise the system and not to cause a failure.

The support area should be concrete or steel.

It cannot be combined with another system of lower performance.

The maximum length of the tensioner is 1500 mm, however, it should not exceed 1443 mm of extension.

The maximum depth of the glass should be 1400 mm (by extension of the tensioner).

The maximum glass width should be 1800 mm.

The slope of the roof should be maintained at a minimum of 5% over a linear meter so that water flows over the glass surface and no water deposits remain on the glass surface.

*For more information, please refer to the Technical Data Sheet.

Learn more about the Netma Canopy System

Download technical documentation of Extralum products

Do you need technical information about this product? I downloaded the required documentation here.

Technical sheet

Learn more about the Canopy Mira System

Extralumalways with the objective of providing full support for your projects, we have created BIM files of our products.

These building information modeling (BIM) files are used to create 3D drawings, providing greater design flexibility and giving a more realistic preview of each project.